Martrix clear

[Bigshod]

Can u over reduce the matrix clear to flow coat it..

thanx

[kpapich]

Yes, with the Matrix MR-0800 series reduces.

Please note, our clears are designed to be mixed as recomened. Sometimes if you need to flow out clear, gun selection and proper set-up will handle that.

Ken Papich

[tims]

what amount to over reduce?

[Matrix System]

The best recomendation is to select the proper gun/tip, coupled with the recomended air pressure and activator (fast,med,slow). If you still feel you need to reduce it more, then add no more than 5% of the "800" series reducers.

Ken Papich

[ironhead59]

yea too much reducer will cause die back,i usually get good flow from correct hardeners and air pressure,just my rec

[tims]

The MS-30 with no reduction will even die without proper flash. No wet on wet.